search

Afx FUS1011213QMVSN User Manual Page 1

Browse online or download User Manual for Lighting Afx FUS1011213QMVSN. AFX FUS1011213QMVSN User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 1
  • Table of contents
  • BOOKMARKS
    • Rated. / 5. Based on customer reviews
Page view 0
FUS Series Fluorescent Wall Sconce Fixture
Model 213, 226
Page 1 of 1 8060085 rev.3
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
This fixture is designed for use in a 120-277VAC, 60Hz. Do not use
on a dimming circuit.
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel. The green ground
screw location is clearly marked on the fixture housing.
This fixture is intended to be used for general indoor lighting in dry
or damp locations only.
Assembly Instructions
1. Preparing for installation
A. Disconnect electrical power before installing or servicing any part of
this fixture.
B. Remove fixture from packaging
C. Insert glass diffuser (1) to mounting band assembly (9), secure with
two supplied short screws (10). Lower diffuser (7) is pre-installed.
2. Wiring.
All wiring must take place inside junction box.
Caution: Make sure power is off at fuse or circuit breaker box. Check power
wires for damage or scrapes. If power supply wires are within three inches of
ballast use wire suitable for at least 90C (194F). Note: Most dwellings built
before 1985 have supply wire rated to 60C. Consult a qualified electrician
before installing.
A. This unit will not operate properly unless connected to a “grounded”
electrical circuit. Electrical shock, over heating, low or no light
output, and shortened lamp life can result if proper grounding is not
done. Securely attach green (or green and yellow) wire to back of fixture with provided hardware.
3. Using luminaire disconnect (provided), insert white supply wire into the hole across from white ballast lead. Insert black hot
supply wire into hole across from black ballast lead. Do not mix wires. Pull on each wire to make sure connections are secure.
Make certain no bare wires are exposed outside of luminaire disconnect.
4.
Fixture mounting.
A. Back pan mounting options
1. Gem Bar Mounting – Secure gem bar (5) to junction box (6)(not supplied) with supplied screws. Install 1 ¼” stem (4)
into the gem bar (5). Use the lock nut to secure stem at the proper length. Install Back pan (3) over 1 ¼” stem and
secured in place with knob. (Note: Adjust length of stem to create secure fit.) (Caution: Do not over tighten knob may
cause cracking).
2. Secure to junction box – Holes supplied in back pan (3) enable direct mounting to junction box (not supplied).
3. Secure to Wall – Holes supplied in back pan (3) enable direct wall mounting (hardware not supplied).
4. Install appropriate lamp (2) by inserting lamp pins into lamp holder and press until lamp snaps in place.
4. Diffuser assembly installation
A. To install the diffuser assembly, align assembly over back pan (3). Secure with 2 flat head mounting screws (8) provided.
B. Restore power at fuse or circuit breaker box.
Limited Factory Warranty
American Fluorescent Corporation hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating
conditions for a period of 2 years from date of shipment from factory. This warranty covers all component parts and extends only to replacement of defective fixture or
components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.
Page view 0
1

Summary of Contents

Page 1 - Safety Precautions

FUS Series Fluorescent Wall Sconce Fixture Model 213, 226 Page 1 of 1 806008

Related models: FUS1011213QMVRB

Comments to this Manuals

No comments
Related products and manuals for Lighting Afx FUS1011213QMVSN
Lighting Afx GNS218SNMVWW User Manual   (1 pages)
Lighting Afx HZS1016218QENSNFSS User Manual   (1 pages)
Lighting Afx IDSR0710118GU27SN User Manual   (1 pages)
Lighting Afx IDS0910118GU27SN User Manual   (1 pages)
Lighting Afx LCS0615213QENWH User Manual   (1 pages)
Lighting Afx IDSS0912118GU27SN User Manual   (1 pages)
Lighting Afx LAS0626214T5MVSN User Manual   (1 pages)
Lighting Afx LAS06261400L30D2SN User Manual   (1 pages)
Lighting Afx HUS118PCEC-LA User Manual   (1 pages)
Lighting Afx NLS0612118QMVSN User Manual   (2 pages)
Lighting Afx MNS1318218QENSN User Manual   (1 pages)
Lighting Afx MRS113SNSCT User Manual   (1 pages)
Lighting Afx NMS65500L30D1WH-DC User Manual   (1 pages)
Lighting Afx RES1211213QMVRB User Manual   (1 pages)
Lighting Afx RDS213WHPLT User Manual   (1 pages)
Lighting Afx QSS60030LBNWF User Manual   (1 pages)
Lighting Afx RIS224SNMV User Manual   (1 pages)
Lighting Afx TAS0613113QMVPCLA User Manual   (1 pages)
Lighting Afx SHS1218218QMVACLN User Manual   (1 pages)
Lighting Afx TYS11231400L30D2SNLA User Manual   (1 pages)
  • Maxus-tools SoftWall Finishing Systems Beco Cables to Go World Helmsman
  • Linksys Flat panel accessories Sega Video games & consoles Sega Video games & consoles Hitachi Optical disc drives Krups Electric kettles
  • Samsung GE-83 UR Bosch BGS7ALL68 Siemens LC955KA40 Whirlpool WDL785SAAM Rexel 2101995EU
  • Panasonic SCZT2 Operations Instructions RIDGID R8452 Operator's Manual Professional Woodworker 51832 Use and Care Manual Singer 14SH654 User Manual Casio EX-Z32 User Manual